Hele discussie weer....
Al het andere wat o.a. Bas schrijft moet je hier ecjht vergeten.
de lopi eruit halen en even apart resetten
Om het op te lossen zou ik de Lopi uit de loc halen en in een andere lok steken en dan programmeren.
I installed a DCC motor decoder in my BlueLine model. Now I have sound, but no movement (OR I have movement, but no sound).The BlueLine Sound decoder in the model and your installed motor decoder are set to two different DCC addresses. To avoid this situation, we recommend you program BlueLine models on the main track, in OPS Mode Programming (waarom is dit Ronald? Omdat in OPS mode de centrale programmeert met adres 0. Zo nemen alle locs dezelfde CV waardes over die de centrale uitstuurt. Handig als je bijvoorbeeld het zelfde adres wilt). This way, you always set the addresses of both decoders at the same time (<== hier staat het nog een keer). If your DCC system does not allow OPS Mode programming on the main line (Lenz), we recommend Direct Mode programming on a Program Track.After programming to a new address, if you get sound but no movement, this means your Blueline Sound decoder is set to the new address but the motor decoder is set to some other address (<== hier staat het nog een keer), probably 3. All you need to do is leave your model on the main track and select loco 03. You should be able to run the model. Use OPS MODE programming to change the address of the motor decoder so that it matches the address of the BlueLine sound decoder.
Blijft een beetje apart van BLi om twee of drie tientjes voor een rij decoder uit te sparen.