Hallo phdirk.Kan jij mij vertellen hoe ik dit moet doen. heb op mijn twincenter gezocht naar de manier hoe dat moet maar niet gevonden. zeer waarschijnlijk ligt hier aan. Alvast bedankt.
Om vanuit het TwinCenter de LNCV-waarden te kunnen programmeren ga je naar het hoofdmenu van het TwinCenter, waarin je ook de taalkeuze etc instelt. Daar kom je door eerst op [menu] en dan op [mode] te drukken. Dan kun je bladeren tot je bij de Loconetmodule bent. Dan geef je eerst het artikelnummer van je Power4 op en het volgnummer, meestal 1. Dan kun je de LNCV-waarden van de Power4 programmeren
4. LocoNet OperationIf one operates the Power 4 with a LocoNet center it has many extended functions,like disconnection of individual boosters and monitoring. All of the booster’s settingsthe can be made with LocoNet programming.4.1 Configuring the Power 4 via LocoNetLocoNet devices like the Power 4 are set up by LocoNet configuration variables(LNCVs). These LNCVs can be programmed with the help of the Intellibox (startingwith software version 1.3), the IB-control (starting with version 1.55) or the TwinCenter(starting with version 1.1).4.1.1 Calling a Power 4 Connect the Power 4 to the LocoNet On the Intellibox (from Software Version 1.3) press the [menu]-key, immediatelyfollowed by the [mode]-key, in order to enter the Basic Settings menu. Scroll to “LocoNet Prog.” with the []-key Press the []-key: Enter the part number for the Power 4 (in this case 63240) and press the [↵]-key