hoe kan je dan volt lager instellen? groetjes
The baseline method for providing the power to operate locomotives and accessories, which shall be supported by all Digital Command Stations and Digital Decoders, is by full-wave rectification of the bipolar NMRA digital signal within the Digital Decoder7. In order to maintain power to the Digital Decoders, gaps in bit transmission are only allowed at specified times (see S-9.2, Section C). The RMS value of NMRA digital signal, measured at the track, shall not exceed by more than 2 volts. the voltage specified in standard S9 for the applicable scale9. In no case should the peak amplitude of the command control signal exceed +/- 22 volts. The minimum peak value of the NMRA digital signal needed to provide power to the decoder shall be +/-7 volts measured at the track. Digital Decoders intended for "N" and smaller scales shall be designed to withstand a DC voltage of at least 24 volts as measured at the track. Digital Decoders intended for scales larger than "N" shall be designed to withstand a DC voltage of at least 27 volts as measured at the track.
Ik heb decoders gekocht via aliexpress (laisdcc) om te proberen.
Er is een nadeel aan de MS2: Je komt niet hoger dan adres 320 met je magneetartikelen e.d.,
Ik heb gehoord als je de mobile station van de stopknop afhaalt dat de decoder volle spanning krijgt. Ik hoop dat mijn fleischmann motoren dat aankunnen. Groetjes